In the process of production and processing in the machinery industry, although some details are very inconspicuous, if we can get inspiration from it, it can be helpful to our work. For you to sum up a mechanic processing industry teacher's tips for your reference.

The tip 1: take the nippers off the vise, another two M4 threaded holes, two plate and the tinctle flat thick 1.5mm steel plate 2, with the aluminum rivet rivet rivet thick 0.8mm hard yellow copper plate 3 to fasten it with the M4 head screw 1 to the jaw, forming a durable soft pliers. This can also protect the hardware parts from being damaged and interchangeability.

 

The trick two: using magnets to absorb small parts (parts) suck and take is not convenient, can absorb a iron plate 2 under the magnet 1, not only can suck a lot of small pieces, but also the iron plate open, small parts will be automatically automatically dumped into the collection box, not enough to hit the heart, but very practical.

 

The trick three: when the belt pulley is driven, the pulley is often skidded with the wheel shaft, and a series of nests are made on the axle with the 15~18mm pit bit. This can form the adsorption force, prevent skidding, and turn waste into treasure, the boss will reward.

 

Tip four: when the inner six corner wrench is short and can not exert enough force, the Guan Congyi section of the inner diameter is slightly larger than that of the wrench. The groove can be inserted into the slot, and can be used as a long handle.

 

The trick five: to tighten the workpiece has the first positioning and then clamping, but for a workpiece, the first clamping and then positioning, because when clamping sure to test the deformation of the workpiece, so, should first clamp and then position, for 6 points positioning, to limit its degree of freedom.